Operating Instructions Supreme 100; Starting The Machine; Servicing - Nilfisk-Advance Supreme 100 Instructions For Use Manual

3 Operating instructions Supreme 100

Manual hose
Fig. 7

3.1 Starting the machine

The control current outlet (low voltage) should be connected
to a control current lead running the length of the pipes.
Both ends of the low-voltage lead should be connected to
the connection panel on the vacuum cleaner. One lead to
each outlet.
The central vacuum cleaner's power cable must be con-
nected to a 230 volt mains socket. The appliance is double-
insulated and does not need to be earthed.
Start/stop button
All models have a start/stop button on the front to start and
stop the power unit, Fig. 8. The start/stop button can also be
used when/if you want to use a Nilfi sk utility inlet to vacuum
direct from the machine (if you do not have a Nilfi sk hose
with remote control) or for testing and demos.
Fig. 8
Manual hose
The vacuum cleaner starts and stops automatically. When
the vacuum hose is connected to a vacuum socket, a metal
ring on the end of the hose closes the control circuit and the
vacuum cleaner starts up. Fig. 7. When the hose is removed
from the vacuum socket, the vacuum cleaner stops.
Wireless handle
If you use a hose with a wireless handle, you can start and
stop the vacuum cleaner using the switch on the handle, Fig.
9. Wireless handles also have the feature of adjusting the
suction power of the cleaner, using the buttons at the hose
handle.
Fig. 9
Wireless Deluxe
Fig. 10

3.2 Servicing

Always unplug the power cord before doing
any service work!
If suction is poor, it indicates that the fl ow of air through the
machine is restricted. This may be due to the following:
• The dust bag is full and should be replaced.
• The fi lter is clogged and should be cleaned.
The vacuum cleaner has a thermal cut-out that trips if the
vacuum cleaner becomes overheated. If this happens - un-
plug the main power cord to reset the vacuum cleaner. Wait
5-10 minutes to allow the machine to cool down. While you
are waiting, check the hose, dust bag and fi lter to be sure
that nothing is blocking the fl ow of air through the machine.
The vacuum cleaner should now start again. If the cut-out
trips again, you need to get a service fi rm to remedy the fault.
The model Supreme 100 should only be operated with
a dust bag and fi lter installed.
Filter
39