Service/Maintenance Guide - Supreme 100; Service/Maintenance Guide - Supreme 150 / Performer 150; Supreme 250 / Performer 250 / Supreme Lcd - Nilfisk-Advance Supreme 100 Instructions For Use Manual

10.1 Service/maintenance guide - Supreme 100

NB! Never vacuum without a fi lter and dust bag installed in the model Supreme 100
Product How often?
Should be replaced
Dust bag
before it becomes
completely full, de-
pending on use but
normally 2-4 times a
year.
Should be checked
Filter in
when changing the
bottom
bag.

10.2 Service/maintenance guide - Supreme 150 / Performer 150 /

Supreme 250 / Performer 250 / Supreme LCD

NB! Never vacuum without a fi lter installed.
Product How often?
Should be emptied
Dust
before the container is
container
3/4 full, depending on
use but normally 2-4
times a year.
Should be replaced
Dust bag
before it becomes
completely full, de-
pending on use but
normally 2-4 times a
year.
Should be shaken
Filter
when the container is
emptied.
NB: Only use dry
cleaning methods
48
Why? How?
Poor suction and Grasp the edge of the lid and open it by pulling upwards. Re-
danger of creat- move the old dust bag by turning the cardboard stiffener to
ing a blockage in the right or left so that the elevation on the nozzle penetrates
the pipe system. the opening in the cardboard. Now slide the bag off the inlet.
Push the opening in the cardboard over the elevation on the
inlet and pull on the new bag. Twist the cardboard to lock the
bag in place. NB! The opening in the card must be adjusted
and pushed past the elevation on the inlet before the card-
board can be locked into place with a twisting action.
NB! Never vacuum without a dust bag installed.
Poor suction can Remove the dust bag as described above. Remove the fi lter
result. Dust can from the bottom. The fi lter can be cleaned by shaking it or
fi nd its way into washing it in water. NB! The fi lter must be completely dry
the motor. before being reinstalled. Replace the cleaned fi lter in the
machine. Press the outer edge of the fi lter down against the
sides of the container so that the fi lter bulges up slightly. Refi t
the dust bag and replace the lid. Check that the lid is sitting
fi rmly in place.
NB! Never vacuum without a fi lter installed.
Why? How?
Danger of block- Release the two handles clamping the dust container. The
age in the pipe handles are easily unlocked by lifting up the handles until
system. they come to a stop. When you pull the handles outwards
away from the cleaner, the container is released. Lift off the
container. Lift out the fi lter and dust bag - see additional
information below. Empty the dust into a plastic bag and
put in dustbin. Any remaining dust or fl uff can be removed
manually.
Poor suction Release the two handles clamping the dust container. The
and danger of handles are easily unlocked by lifting up the handles until
creating a block- they come to a stop. When you pull the handles outwards
age in the pipe away from the cleaner, the container is released. Lift off the
system. container. Lift out the fi lter. Then remove the dust bag by
pulling the bag's cardboard stiffener off the nozzle. Replace
in reverse order.
To maintain Release the two handles clamping the dust container. The
good suction handles are easily unlocked by lifting up the handles until
power. they come to a stop. When you pull the handles outwards
away from the cleaner, the container is released. Lift off
the container. Do not remove the fi lter from the container.
Instead, give the fi lter a light shaking inside the container
to loosen dust from the fi lter and allow it to fall into the
container. Lift out the bag fi lter. If a dust bag is being used
- remove it. Then empty the dust from the container in a
suitable place.