Cisco TelePresence C20 Administrator's Manual page 14

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents
About snapshots and remote
monitoring (TC7.3.3 and later)
Snapshots of local input sources
If the Remote Monitoring option key is installed on the video
system, snapshots of the video system's input sources are
displayed on the Call Control page.
Snapshots are displayed both when the video system is idle,
and when in a call.
This feature may be used when administering the video
system from a remote location, for example to check the
camera view and control the camera.
Far end snapshots
If the Remote Monitoring option key is installed on the video
system, far end snapshots may also be captured. Whether or
not the Remote Monitoring option key is installed on the far
end video system, does not make any difference.
Far end snapshots are prohibited during encrypted calls.
PLEASE BE AWARE THAT IF YOU ENABLE THE REMOTE
MONITORING OPTION YOU MUST MAKE SURE THAT YOU COMPLY
WITH LOCAL LAWS AND REGULATIONS WITH REGARD TO PRIVACY
AND PROVIDE ADEQUATE NOTICE TO USERS OF THE SYSTEM THAT
THE SYSTEM ADMINISTRATOR MAY MONITOR AND CONTROL THE
CAMERA AND SCREEN. IT IS YOUR RESPONSIBILITY TO COMPLY
WITH PRIVACY REGULATIONS WHEN USING THE SYSTEM AND
CISCO DISCLAIMS ALL LIABILITY FOR ANY UNLAWFUL USE OF
THIS FEATURE.
D14637.17 Profile C20 and Quick Set C20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface Web interface
Navigate to: Call Control
System settings
www.cisco.com — Copyright © 2010-2015 Cisco Systems, Inc. All rights reserved.
14
Administrator Guide
Setting passwords Appendices
View snapshots from the input sources
Install the Remote Monitoring option key in order
to view snapshots from the selected main source
or presentation source in this area.