Cisco TelePresence C20 Administrator's Manual page 128

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents
Connecting the Cisco
TelePresence Touch 8 controller
The Cisco TelePresence Touch 8 controller is an alternative to
the remote control and on screen menus.
When a Touch controller is connected to the codec, the
remote control cannot be used. You have to disconnect
(unpair) the Touch controller in order to to use the remote
control.
Touch 8 can can be used with a C Series codec running
software version TC4.1 or later.
D14637.17 Profile C20 and Quick Set C20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface
Connecting the Touch controller
The Touch controller must be connected to the codec via
LAN. The connection is via the provided power adapter, as
illustrated above.
Make sure that the codec's
setting is turned On to be able to connect.
The process of associating the Touch controller to the codec
is called paring. Note that the codec is signalling that it is
available for pairing for only 30 minutes after it is switched on.
We recommend that the Touch controller and video system is
kept on the same subnet.
1 Power over Ethernet (PoE) must be disabled on the Ethernet switch, because the inline power adapter does not support PoE input from the
Ethernet switch.
You will find this setting in the Advanced Configuration on-screen menu (remote control) or in the System Configuration page on the web
2
interface.
System settings
Power
adapter
Codec address
NetworkServices > SSH > Mode
2
www.cisco.com — Copyright © 2010-2015 Cisco Systems, Inc. All rights reserved.
128
Administrator Guide
Setting passwords
To LAN socket (Ethernet)
To power socket
Touch controller set-up
Once the Touch controller is connected to power, the set-up
procedure begins. Follow the instructions on screen.
If the codec is not in the list of available codecs displayed
on the Touch controller, you can choose a codec
manually by entering its IP address.
If the Touch controller needs software upgrade, new software
will be downloaded from the codec and installed on the unit
automatically as part of the set-up procedure. The Touch
controller restarts after the upgrade.
You can verify that the Touch controller is successfully paired
to the codec by checking that the codec address is displayed
in the top banner.
If you want more details on Touch installation, please read the
Cisco TelePresence Touch 8 inch Installation Guide, which is
available on the Cisco web site.
Appendices Appendices
1