Cisco TelePresence C20 Administrator's Manual page 114

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents
Video Selfview
Determine if the main video source (self-view) shall be displayed on screen.
This setting is obsoleted by the Video SelfviewDefault Mode setting.
Requires user role: USER
Value space: <Off/On>
Off: Do not display self-view on screen.
On: Display self-view on screen.
Video Selfview: On
Example:
Video SelfviewPosition
Select where the small self-view PiP (Picture-in-Picture) will appear on screen.
This setting is obsoleted by the Video SelfviewDefault PIPPosition setting.
Requires user role: ADMIN
Value space: <UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/LowerLeft/
LowerRight>
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center of the screen.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear on the left side of the screen, in center.
CenterRight: The self-view PiP will appear on the right side of the screen, in center.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
Video SelfviewPosition: CenterRight
Example:
D14637.17 Profile C20 and Quick Set C20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings
Video SelfviewDefault Mode
Determine if the main video source (self-view) shall be displayed on screen after a call.
The position and size of the self-view window is determined by the Video SelfviewDefault
PIPPosition and the Video SelfviewDefault FullscreenMode settings respectively.
Requires user role: ADMIN
Value space: <Off/Current/On>
Off: self-view is switched off when leaving a call.
Current: self-view is left as is, i.e. if it was on during the call, it remains on after the call; if it
was off during the call, it remains off after the call.
On: self-view is switched on when leaving a call.
Video SelfviewDefault Mode: Current
Example:
Video SelfviewDefault FullscreenMode
Determine if the main video source (self-view) shall be shown in full screen or as a small
picture-in-picture (PiP) after a call. The setting only takes effect when self-view is switched on
(see the Video SelfviewDefault Mode setting).
Requires user role: ADMIN
Value space: <Off/Current/On>
Off: self-view will be shown as a PiP.
Current: The size of the self-view picture will be kept unchanged when leaving a call, i.e. if it
was a PiP during the call, it remains a PiP after the call; if it was fullscreen during the call, it
remains fullscreen after the call.
On: The self-view picture will be shown in fullscreen.
Video SelfviewDefault FullscreenMode: Current
Example:
www.cisco.com — Copyright © 2010-2015 Cisco Systems, Inc. All rights reserved.
114
Administrator Guide
Setting passwords Appendices