USER MANUAL w w w . n o k t a d e t e c t o r s . c o m...
Page 2
Nokta Detectors a ms to rema n a lead ng p oneer n ts sector, w nn ng the trust of ts consumers and always be ng the preferred cho ce for metal detect ng.
CONTENTS WARNINGS : ....................................ASSEMBLY : ..................................... CORRECT WAY OF HOLDING : ..........................CORRECT WAY OF SWEEPING : ........................BATTERY 11-12 : ....................................DEVICE INTRODUCTION 13-14 : ..........................PRINCIPLES OF SEARCHING : ..........................TURNING ON THE DEVICE AND SETTINGS 16-18 : ..............
► The dev ce can only be opened and repa red by author zed serv ce techn c ans. The warranty w ll be vo ded f the dev ce s opened by you or an unauthor zed person. NOKTA DETECTORS...
WARNINGS Do not use the dev ce ndoors. The dev ce w ll constantly g ve target s gnals ns de places l ke homes where there are many metals present. Use the dev ce outdoors, n open f elds. Do not let another detector or an electromagnet c dev ce come n close prox m ty (10m (33ft.)) to the dev ce.
11) Fasten ng Screw ns de the cover, attach the cover to the co l and press f rmly to make them st ck together. Once 12) Washers the cover s attached, you cannot take t o . 13) Headphones NOKTA DETECTORS...
Page 7
ASSEMBLY Insert the co l cable nto the shaft. Do not extend After plac ng the shaft on the co l as shown n the Place the washers nto the open ngs on both s des at the shaft pr or to th s step! Pull the cable out from the end of the extens on shaft.
Page 8
After adjust ng the shaft length to up aga n mak ng sure that t s n place and and t ghten. your he ght, re-t ghten. secure t by t ghten ng the tw st lock. NOKTA DETECTORS...
Page 9
ASSEMBLY Place the system box and the battery n the r proper compartments of the system box case. Insert the battery cable through the hole on the case, plug t nto the battery nput socket underneath the system box and t ghten securely. You may hang the system box around your Plug the other end of the system connect on Insert the end connector on e ther end of the...
It s very mportant to adjust the shaft to your he ght correctly to be pos t on, your arm s relaxed and the search co l s approx mately 5cm able to search w thout d scomfort and fat gue. (~2'') above the ground. NOKTA DETECTORS...
CORRECT WAY OF SWEEPING Wrong search co l angle. Wrong search co l angle. Correct search co l angle. Incorrect way of sweep ng. Correct way of sweep ng. It s mportant to keep the search co l The search co l must be parallel to the parallel to the ground n order to get ground at all t mes.
LOW BATTERY: When the batteries are low, the optional car charger with the device will produce warning sound lithium polymer battery and approximately once every minute. The device will charge your battery on-the-go shut down automatically 3-4 hours after the as well. Optional warning. NOKTA DETECTORS...
For deta ls please mode as well as turn ng ground no se. For deta ls connect the headphones see page 17. on/o the dev ce. please see page 18. to the system box. NOKTA DETECTORS...
Page 15
DEVICE INTRODUCTION Search Co l Input Socket: Battery Input Socket: Is the connect on po nt Is the connect on of the co l to the system po nt of the battery to D scr m nat on Ind cator: Shows box.
3- For correct metal detect on, the way you hold the shaft and sweep the search co l and keep ng the co l parallel to the ground are very mportant factors. Before start ng to search, please refer to the related sect ons n the manual. (pages 9-10) NOKTA DETECTORS...
TURNING ON THE DEVICE AND SETTINGS TURNING ON THE DEVICE Rotate the sens t v ty knob to max mum and the ground balance knob to the m d-level. GROUND SENSITIVITY BALANCE To turn on the dev ce, rotate the search mode knob to the des red mode. Turn the same knob to OFF pos t on to when you want to turn o the dev ce.
Sens t v ty s also the depth sett ng for the dev ce. Therefore, t s recommended that you do not lower t too much suddenly but gradually decrease t to determ ne the level where you are not gett ng any nterference and cont nue search ng. NOKTA DETECTORS...
Ground balanc ng s a process through wh ch the metal detector s able to cancel out the negat ve e ects caused by ground m neral zat on. Golden Sense ground balance sett ng cons sts of 3 d erent levels: 1) RECOMMENDED SETTING...
For p npo nt ng the exact locat on of the target, move the dev ce s n d scr m nat on mode, search co l over the target w th short and faster/slower the LEDs on the handle w ll l ght up sweeps. at the same t me. NOKTA DETECTORS...
SEARCHING AND METAL DETECTION SEARCH MODES All Metal: Th s s the deepest mode of the dev ce. The dev ce w ll not d scr m nate metals n th s mode. It w ll produce one warn ng tone for all metals and the LEDs on the metal d scr m nat on nd cator w ll not l ght up.
NOTE: Many metals cons dered to be trash may not produce a ferrous metal s gnal due to the r alloy compos t on. For example, pull tabs may be sensed as a non-ferrous metal by most detectors because the r s gnal s very s m lar to that of gold. NOKTA DETECTORS...
TECHNICAL SPECIFICATIONS Operat ng Pr nc ple: Induct on Balance Operat ng Frequency: 17.5 KHz Search Modes: 3 (All Metal/D scr m nat on/Iron O ) Metal Ident f cat on: LED and aud o warn ng Aud o D scr m nat on: 2 tones V sual D scr m nat on: 2 LEDs (Ferrous &...
Need help?
Do you have a question about the GOLDEN SENSE and is the answer not in the manual?
Questions and answers