Nokta GOLDEN SENSE Quick Manual

1
TURNING ON THE DEVICE
SENSITIVITY
2
SENSITIVITY SETTING
Hold ng the search co l 5cm.
above the ground, sweep t
r ght and left.
3
SEARCHING AND METAL DETECTION
After the ground balance and
sens t v ty sett ngs are
adjusted, you can start
search ng by l ft ng the search
co l 5cm. above the ground and
sweep ng t r ght and left,
keep ng t parallel to the
ground.
When the dev ce detects a metal, t w ll produce an aud ble tone. For p npo nt ng the exact locat on of the target, move the search co l
over the target w th short and faster/slower sweeps.
GROUND BALANCE
1) RECOMMENDED SETTING
MID-LEVEL
2) LEFT AREA
GROUND BALANCE
3) RIGHT AREA: Is used to el m nate h gh m neral zed rocks and so ls. If you are on a h ghly m neral zed ground and the dev ce s st ll gett ng
ground no se w th the ground balance set at m d-level, turn the ground balance knob to the r ght n very small ncrements to el m nate the
no se.
The most mportant th ng to pay attent on here s that as the ground balance goes nto the r ght area, the dev ce w ll start los ng depth
for some non-ferrous metals except for gold. When the ground balance sett ng reaches the max mum po nt the dev ce w ll detect ron
and gold but t w ll not detect some non-ferrous metals.
QUICK GUIDE
Rotate the
sens t v ty knob
to max mum
and the ground
balance knob to
the m d-level.
Golden Sense ground balance sett ng cons sts of 3 d erent levels:
1) MID-LEVEL: O ers the most deal and stable detect on capab l ty on d erent types of
grounds w thout sacr f c ng depth.
3) RIGHT AREA 2) LEFT AREA: Recommended for more prec se detect ons and for exper enced users.
The dev ce may generate false s gnals n chang ng ground cond t ons, even over holes
dug for test ng. Therefore, f you set the ground balance n th s area, you have to take
th s factor nto cons derat on.
Turn on the dev ce
by sett ng the
search mode knob
to ALL METAL.
If the detector em ts false s gnals due to nterference,
reduce the sens t v ty unt l the s gnals go away and
start search ng.
Sens t v ty s also the depth sett ng for the dev ce.
Therefore, t s recommended that you do not lower t
too much suddenly but gradually decrease t to
determ ne the level where you are not gett ng any
SENSITIVITY
nterference and cont nue search ng.
Approx mately 20
seconds later, the LEDs
on the handle w ll go o
and you w ll hear a tone
nd cat ng that the dev ce
s ready to use.
To avo d m ss ng smaller and
deeper targets, sweep the
search co l both from r ght to
left and left to r ght over each
area you are scann ng, sl ghtly
overlapp ng the sweeps as you
move forward.