Page 2
Nokta Detectors aims to remain a leading pioneer in its sector, winning the trust of its consumers and always being the preferred choice for metal detecting. w w w. no ktade tec tors.com...
HOT ROCKS AND SEARCHING IN ROCKY AREAS 26-27 ....... EFFECTS OF HOT ROCKS IN GROUND TRACKING ....... METALS UNDER HOT ROCKS 27-28 ..................MESSAGES ................................. FACTORY and STARTUP SETTINGS ................TECHNICAL SPECIFICATIONS ....................w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 2...
(2) this device must accept any interference received, including interferen- government regulations and environmental ce that may cause undesired operation. requirements. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 3...
Place the system box on the rail behind the armrest and push forward. Then secure by tightening the nuts. Attach the armrest strap by inserting it through the holes. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 4...
Page 6
(HANDLE) and secure it by height, secure by tightening the twisting the connector. Finally, twist lock. secure the cable by attaching the clamps at 3 di erent spots. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 5...
It is important to keep the search coil The search coil must be parallel to the parallel to the ground in order to get ground at all times. accurate results. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 6...
Alkaline batteries. This does not a ect the total runtime. ROCK ROCK IRON IRON ROCK ROCK IRON IRON Target Target Target Target General Search General Search Low Battery General Search w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 7...
To turn on the device, press the power switch to (1) position. The startup tone will be heard and after the Nokta logo is displayed for a short period of time, the main screen will come up on the LCD panel.
Nokta logo is displayed for a few seconds. This information will stay on the screen as long as you hold the button pressed. Please have his information ready when you contact your dealer regarding your device.
This way you don't need to go back and check the LCD panel constantly. This provides great comfort during searching. The numeric display backlight turns on only when a number is displayed to save power. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 10...
D E V I C E I NTRO DU C TI O N ME NU The menu screen allows you to access all the FORS Gold settings. You can go to the menu screen by pressing one of the up/down/+/- switches while on the main screen and adjust the settings of the device.
Page 13
When you turn off and on the device, it will start with the last brightness level you chose. This setting is common to all modes; changes will take effect in all modes. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 12...
Page 14
LANGUAGE LANGUAGE: Is used to change the language of the device. The FORS Gold menus can be viewed in 10 languages. At initial startup, the factory default language will be displayed. The user can change the language in the menu. When you turn o and on the device, it will start with the last language you selected.
* Disabled menu options ( that cannot be changed by the user) will appear grayed out. The disabled option may be active in another mode. (For example; ID Masking appears disabled in the General Search mode but active in other modes) w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 14...
Page 16
Developed for use in gold fields, this mode is deeper than DI3. It provides more depth for nugget searching and minimizes the e ects of hot rocks. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 15...
Page 17
TVs. In such a case, first make sure that the device is silent by making the sensitivity and threshold adjustments and then ground balance. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 16...
Ground balance can be done in three ways in FORS Gold: Automatic, Manual or Ground Tracking. During automatic or manual ground balancing, when you press the ground balance button, no matter what mode you are using, the device will unnoticeably revert to the General Search mode and the audible tones will be heard accordingly.
Page 19
FORS Gold is designed in a way that you can easily auto ground balance it on all types of ground. Therefore, we recommend that you use automatic ground balance at start up.
Page 20
(such as gold nuggets). IMPORTANT! When air testing, be sure that Ground Tracking is o . Otherwise, the device will try to ground balance over the target and lose depth. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 19...
Page 21
However, in areas where the soil has been disturbed by digging or filling up, or in geologically complex areas -commonly encountered in gold fields- you may have to ground balance frequently to accommodate changing ground conditions. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 20...
ID Masking is also at its factory default value), you can increase the sensitivity setting gradually to the highest level where there are no popping sounds. During searching, if the device starts receiving noise, lower sensitivity gradually. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 21...
● Low probability but possible in tough ground conditions and rocky fields. ●● Not its typical ID but high probability due to target shape and orientation in tough ground conditions. ●●● High probability. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 22...
IDs up to 40, 35 will fall in the masked range so the signal strength may diminish and depth may decrease. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 23...
Pinpointing is to determine the center or the exact location of a detected target. FORS Gold operates on the principle of motion. This means that you must move the search coil over the target or the target over the search coil, in order for the device to detect it. In the pinpoint mode, however, the device constantly gives signal when you hold the search coil still over the target.
S W E EP S P EED and TARGE T I D ENTI FI C ATI O N FORS Gold is a very fast responding detector. When you detect a target with the FORS Gold, in order to get an accurate ID of the target, instead of narrowing the sweeps and making quick sweeps over the target like in other detectors, you should make wider and deliberate sweeps.
''boing'' sound when the search coil is swept over them. The device will not give an ID for these rocks regardless of the signal strength. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 26...
For this reason, a missed target by another detector makes you lucky for reading this manual and using the FORS Gold. The other reason is a geological one and is a commonly encountered situation in gold prospecting fields.
Page 29
M E TA L S U N D ER H OT RO C KS No matter what the reason is, a well adjusted FORS Gold will increase your chance of finding metals under hot rocks. The combined e ect of a metal and a hot rock is less than the metal's e ect by itself and the received ID will be di erent than the metal's expected ID.
This message appears when the battery level drops below a certain point. The device may continue to work a few more hours. Meanwhile, please change the batteries. w w w.no kta d etec tor s. com NOKTA DETECTORS FORS / Page 29...
5. Turn o and on the device again. Go to the menu and be sure that the factory defaults are restored. w w w.n ok ta d e te c tor s. com NOKTA DETECTORS FORS / Page 30...
Battery 4 AA Alkaline Warranty 2 years Nokta Detectors reserves the right to change the design, specifications or accessories without notice and without any obligation or liability whatsoever. w w w. no ktade tec tors.com NOKTA DETECTORS FORS / Page 31...
Need help?
Do you have a question about the FORS Gold and is the answer not in the manual?
Questions and answers