Assembly Instructions - Everlast 1653501 Owner's Manual

Assembly Instructions

!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS.
PLEASE READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from
unfolding accidentally during shipping. If this strap is not removed properly the treadmill
could spring open unexpectedly and cause injury if someone is standing near the treadmill
when the strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the
treadmill is positioned flat on the ground, in the orientation it would be in if you were using
the treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This
could cause the treadmill's folding mechanism to spring open. If the end of the Velcro strap
(that you need to grab to remove it) happens to be under the treadmill deck, reach under
the deck to grab it, but do not tilt the treadmill up to gain access to the strap end.
Unpack the treadmill and locate the hardware pack. The hardware pack is separated into
five sections; one section containing tools and four sections labeled steps 1-4 which
contain the hardware needed for assembly of each step. The assembly steps below are
numbered one through four and correspond to the hardware in the numbered sections of
the hardware pack. Remove only the hardware for the step you are currently assembling to
avoid confusion and mix ups.
Customer Service 1-888-707-1880 Dyaco Canada Inc. 2013
5
Email: customerservice@dyaco.ca