Assembly Instructions - Everlast EV651 Owner's Manual

ASSEMBLY INSTRUCTIONS

!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS.
PLEASE READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly. The Velcro strap
installed around the treadmill base prevents the treadmill from unfolding accidentally during
shipping. If this strap is not removed correctly, the treadmill could spring open unexpectedly
and cause injury if someone is standing near the treadmill when the strap is removed.
To ensure your personal safety during the removal of the shipping strap, please make sure
the treadmill is positioned flat on the ground, in the orientation it would be in if you were
using the treadmill. Do not turn the treadmill up on its side while removing the shipping
strap. This could cause the treadmill's folding mechanism to spring open. If the end of the
Velcro strap (that you need to grab to remove it) happens to be under the treadmill deck,
reach under the deck to grab it, but do not tilt the treadmill up to gain access to the strap
end.
Unpack the treadmill and locate the hardware pack. The hardware pack is separated into
five sections; one section containing tools and four sections labelled steps 1-4 which
contain the hardware needed for assembly of each step. The assembly steps below are
numbered one through four and correspond to the hardware in the numbered sections of
the hardware pack. Remove only the hardware for the step you are currently assembling to
avoid confusion and mix-ups.
The decals shown have been placed on the treadmill. If a decal is missing or illegible,
please call our Customer Service Department, to order a free replacement decal
(see ORDERING REPLACEMENT PARTS). Apply the decal in the location shown.
Note: The decal shown at the right is 50% of actual size.
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
Serial Number Decal
5
Dyaco Canada Inc. 2021