Work Piece And Work Area Set Up - Drill Master 91938 Owner's Manual & Safety Instructions

Work piece and Work Area Set Up

1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using the vise
to prevent movement while working:
a. To use the Quick Release (31), put the Quick
Release (31) tab in the position shown in
Figure E and push the Vise Handle (28)
up against the workpiece. Then tighten the
Vise Handle (28). When releasing, loosen the
Vise Handle (28) a few turns, lift up the Quick
Release (31), and pull the Vise Handle (28) open.
place Workpiece
Quick
Release (31)
Vise Handle (28)
Figure E: Vise Components
Page 10
Here
For technical questions, please call 1-888-866-5797.
b. To cut at various angles (up to 45º),
adjust the Angle Scale (35) by loosening the
two Bolts (41 & 44) as shown in Figure F.
Adjust the Angle Scale to the desired setting
and then tighten the Bolts (41 & 44).
Upper Two
Screw Holes
Bolts (41 & 44)
Angle Scale (35)
Figure F: Angle Scale
c. To reposition the Angle Scale (35),
remove both of the Bolts (41 & 44), and
reattach the Angle Scale at the upper
two screw holes. See Figure E.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Item 91938