Work Piece And Work Area Set Up; General Operating Instructions - Drill Master 6" Cut-Off Saw Owner's Manual & Safety Instructions

Work piece and Work area Set up

1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.

General Operating instructions

CautiOn! Friction from cutting will heat both the
Wheel and the workpiece. Be careful when handling
the workpiece and do not overwork the Cut-Off Saw as
the Wheel can become damaged from overheating.
1. Release the Safety Chain and guide the
Housing to rest at ifs full upward position.
2. Adjust the Angle Guide as needed.
3. Place the workpiece against the Angle
Guide and the Clamp in place.
4. Plug the Power Cord into a 120V~
grounded, electrical outlet.
5. Squeeze and hold the Trigger to start the Saw.
Item 69438 For technical questions, please call 1-800-444-3353.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using the clamp
to prevent movement while working.
6. With one hand on the Handle and the other hand
clear, slowly bring the Saw down, letting the Saw
do the work. Do not apply excessive force.
7. After making the cut, release the Power
Switch and raise the Saw.
8. Wait until the unit comes to a complete
stop then remove the workpiece.
9. To prevent accidents, turn off the tool and disconnect
its power supply after use. Lower the Housing
and secure with the Safety Chain. Clean, then
store the tool indoors out of children's reach.
Page 9