Locating Connectors On The Hot-Swap Hard Disk Drive Backplanes - Lenovo ThinkServer TD230 Hardware Maintenance Manual
Machine types: 1027, 1029, 1039, and 1040
Hide thumbs
Also See for ThinkServer TD230:
- Installations- und benutzerhandbuch (162 pages) ,
- Guía del usuario y de instalación manual (162 pages) ,
- Manual d’installation et d’utilisation (160 pages)
Table of Contents
Advertisement
Note: Before clearing the CMOS, turn off the server and disconnect the power cord. Move the jumper from
pins 1-2 to pins 2-3. Wait more than five minutes; then, move the jumper back to the normal position (pins
1-2 is short circuited) to clear CMOS.
Locating connectors on the hot-swap hard disk drive backplanes
There are two hot-swap hard disk drive backplanes installed in the server model with hot-swap hard disk
drives. Figure 10 "Connector locations on the hot-swap hard disk drive backplanes" on page 37 shows
the connector locations on the hot-swap hard disk drive backplanes.
Figure 10. Connector locations on the hot-swap hard disk drive backplanes
1
SATA/SAS signal connector 2
2
SATA/SAS signal connector 3
3
Power connector
4
Hot-swap hard disk drive 3 connector
5
Hot-swap hard disk drive 2 connector
6
Power connector
7
Hot-swap hard disk drive 1 connector
8
Hot-swap hard disk drive 0 connector
9
First hot-swap hard disk drive backplane
10
SATA/SAS signal connector 1
11
SATA/SAS signal connector 0
12
Second hot-swap hard disk drive backplane
.
Chapter 4
Locating parts, controls, LEDs, and connectors
37
Advertisement
Table of Contents
