Installing Or Removing The Thinkserver Raid 100 Upgrade Key For Advanced Raid - Lenovo ThinkServer TD230 Hardware Maintenance Manual

5. If you are instructed to return the removed Ethernet card to the manufacturer, follow all packaging
instructions and use any packaging materials that are supplied to you for shipping.
6. To complete the removal procedure, go to "Completing the parts replacement" on page 122.
Installing or removing the ThinkServer RAID 100 Upgrade Key for
Advanced RAID
This section provides instructions on how to install or remove the ThinkServer RAID 100 Upgrade Key for
Advanced RAID (hereafter called the RAID 5 key). The RAID 5 key is an activation key, which you can install
on the system board to enable the RAID 5 configuration function of the onboard SATA RAID for your server.
Installing the RAID 5 key
Attention:
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and
"Guidelines" on page 39. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to install the RAID 5 key.
To install the RAID 5 key, do the following:
Attention: Electrostatic discharge (ESD) can damage the RAID 5 key. Always ground yourself and use a
ground strap before touching the option. Perform the following procedure at an ESD-safe workstation.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 43.
3. Lay the server on its side for easier operation.
4. Touch the static-protective package that contains the RAID 5 key to any unpainted surface on the
outside of the server. Then, remove the RAID 5 key from the package.
.
Chapter 5 Replacing FRUs
77