Travis Industries 564 Installation And Owner's Manual page 14

REMOTE CONTROL OPERATION (continued)
ON/OFF
5. Heater " " button: Press this button to turn the heater ON. The heater will always start at high heat setting
1500W. To turn the heater off press this button again.
HIGH button: Press the high button to switch the heater to high heat setting 1500W.
LOW button: Press the low button to switch the heater to LOW heat setting 750W.
TEMP button: Press the TEMP. button to switch the heater to AUTO mode. See page 15 for details.
6. To turn off the heater unit completely press the
Note: The remote control must be within about 20 feet (6 meters) of the
fireplace insert and not too far off to either side.
Important! If the flame does not activate after the POWER ON/OFF button is pressed, press the
DISPLAY ON/OFF button to activate the flame. If the flame does not appear, press the
POWER ON/OFF button again.
WARNING: Before undertaking maintenance unplug the fireplace insert.
button once.
14
(C) Travis Industries 100-01382