Installation Notes; Selecting Wall Plugs And Screws; Recommended Screws; Mounting The Wall Bracket - Fronius Galvo Operating Instructions Manual

Installation notes

Selecting wall
IMPORTANT! Different fixings may be required to fit the wall bracket depending on the
plugs and screws
type of underlying surface. Fixings are therefore not included in the scope of supply of the
inverter. The installer is responsible for selecting the right type of fixing.
Recommended To install the inverter, the manufacturer recommends the use of steel or aluminium screws
screws with a diameter of 6 - 8 mm.
Mounting the wall
bracket
Mounting the in-
verter on a mast
?
Example of a mast fixing kit
8
NOTE! When mounting the wall bracket, ensure that the wall bracket is not
warped or deformed.
Fronius Galvo
Installation Help
When mounting the inverter on a mast or a
vertical carrier, Fronius recommends the
use of a standard mast fixing kit.
This kit enables the inverter to be mounted
on round or rectangular masts with various
cross-sections.