Replacing The Secondary Hard Disk Drive - Lenovo THINKSTATION 7783 Hardware Maintenance Manual

10. Slide the new hard disk drive into the drive cage until it snaps into position.
11. Align the drive cage pivot pin with the slot
cage into the chassis.
12. Connect the signal cable and the power cable to the new hard disk drive.
13. Press down on the metal latch
computer until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard disk drive cage. The
arrows are aligned when the hard disk drive is in the proper position.
Figure 29. Installing the primary hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 102.

Replacing the secondary hard disk drive

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkStation User Guide. To obtain a copy of the ThinkStation User Guide, go to:
http://www.lenovo.com/ThinkStationUserGuides.
Note: Depending on your model type, your computer might come with a secondary hard disk drive bay for
installing or replacing a secondary hard disk drive.
This section provides instructions on how to replace the secondary hard disk drive.
To replace the secondary hard disk drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
1
in the upper drive cage and slide the hard disk drive
2 and pivot the drive cage into place, and then slide it to the front of the
.
Chapter 9 Replacing FRUs
95