Table of Contents
Advertisement
MACHINE SPECIFICATIONS
Saw Spindle
Cutting Table
Detachable Legs
This Daltool Tile Saw is designed and intended
for the professional contractor. The machine is
equipped with a height adjustable cutting head.
The movable sawing table has 4 ball bearing
guide rollers for precise and smooth cutting
feed. Through continuous supply of cooling
water, the cutting quality is improved and the
wear on the saw blade is minimized. The coo-
ling water also absorbs the saw dust. The quali-
ty and construction of this tile saw meet the hig-
hest standards. The design is based on longevi-
ty and minimal maintenance.
The stainless steel construction contributes to a
stable, rigid and durable sawing machine. The
4 detachable legs are to be installed in the leg
sockets at the underside of the water container
and fastened with the knob.
Blade Guard
Water Pump
Cutting Head
The cutting head is constructed of welded steel
components.
Blade Guard
The Blade Guard is a welded steel plate cap,
simple to remove and install for changing the
saw blade by unscrewing 2 knobs.
Saw spindle
The spindle flange is mounted on the saw spind-
le. The saw flange is to be mounted on the saw
spindle with a hexagon nut to clamp the saw
blade.
Cutting table
The cutting table is constructed of welded stain-
less steel components, equipped with anti-slip
rubber and adjustable side stop. The saw table
is equipped with 4 ball bearing guide rollers for
precise and smooth cutting feed.
Cooling system
The electrical water pump is switched on simul-
taneously with the saw motor and supplies coo-
ling water to both sides of the saw blade. A
drain hole, with a plug, is located in the water
container. Mud flaps prevent most of the water
mist and make sure most water flows back in
the water container.
Technical Data:
Type...............................................daltile 1020 TS
Capacity.........................................................2 HP
Blade diameter/Arbor ........................10" / 5/8"
Cutting height ......................................max. 3 1/8"
Saw spindle speed .............................3.360 RPM
Cutting length...................................................20"
Cutting table dim.....................18 5/8" x 15 3/4"
Length...............................................................42"
Width.......................................................... 23 5/8"
Height (without legs) ................................ 24 1/2"
Weight ........................................................176 lbs
Noise level............................................. 89 dB (A)
Noise level during sawing ................... 98 dB (A)
DALTILE 1020TS OPERATING MANUAL V02/2004R1 PAGE 11
Advertisement
Table of Contents
