Lenovo THINKPAD T510 Hardware Maintenance Manual page 51

Table 2. Numeric error codes (continued)
Symptom or error
0191
System Security—Invalid Remote Change requested.
0192
System Security— Embedded Security hardware tamper
detected.
0193
RF antenna has been removed
0194
The computer has been carried through a security gate
0195
Security hardware tamper detected
0196
Security hardware removed
0197
Invalid remote change requested.
0199
System Security— Security password retry count
exceeded.
01C8
Two or more modem devices are found. Remove all but
one of them. Press <Esc> to continue.
01C9
Two or more Ethernet devices are found. Remove all but
one of them. Press <Esc> to continue.
01C9
More than one Ethernet devices are found. Remove one
of them. Press <Esc> to continue.
01CA
More than one Wireless LAN devices are found. Remove
one of them.
0200
Hard disk error—The hard disk is not working.
021x
Keyboard error.
0220
Monitor type error—Monitor type does not match the one
specified in CMOS.
0230
Shadow RAM error—Shadow RAM fails at offset nnnn.
FRU or action, in sequence
1. Run BIOS Setup Utility, and then save current
setting by pressing F10.
2. System board.
System board.
Enter the supervisor password.
Enter the supervisor password.
1. Enter BIOS Setup Utility by entering supervisor
password, and select Password ➙ Security Chip
➙ Clear Security Chip to clear this error.
2. Security chip.
3. System board.
1. Enter BIOS Setup Utility by entering supervisor
password, and select Password ➙ Security Chip
➙ Clear Security Chip to clear this error.
2. Security chip.
3. System board.
The remote configuration for the security chip has
failed. Confirm the operation and try again.
1. Run BIOS Setup Utility, and then save the current
setting by pressing F10.
2. System board.
1. Remove either a Mini-PCI Card or a modem
daughter card. Otherwise, press Esc to ignore
the warning message.
2. System board.
1. Remove either a Mini PCI Ethernet card or an
Ethernet daughter card. Otherwise, press Esc to
ignore the warning message.
2. System board.
1. Remove the Ethernet device that you installed; or
press Esc to ignore the warning message.
2. System board.
1. Remove the wireless LAN device that you
installed.
2. System board.
1. Reseat the hard disk drive.
2. Load Setup Defaults in BIOS Setup Utility.
3. Hard disk drive.
4. System board.
Run interactive tests of the keyboard and the auxiliary
input device.
Load Setup Defaults in BIOS Setup Utility.
System board.
Chapter 4
.
Related service information
45