Advertisement
INSTALLATION INSTRUCTIONS
2. CHANGE LOCK HAND (IF NECESSARY):
NOTE: The locks are shipped as ordered from factory. If it is
necessary to change the hand of the lock, follow the steps
below:
TO CHANGE HAND OF LOCK CASE:
A. With bolt fully extended, insert change pin (included in the
hardware pack) into hole. (It will snap over a groove on the
main shaft, holding it in place.)
B. Remove set screw in bolt so bolt can be removed.
C. Rotate bolt and reinstall on to shaft. Do not remove spring.
D. Apply thread locking compound to set screw.
Loctite 242 recommended.
E. Install and tighten set screw (from other side, as shown).
F. Remove change pin.
TO CHANGE HAND OF LEVERS:
A. Loosen 5/32" socket cap screw and remove lever.
B. Rotate handle to opposite position.
C. Apply thread locker to screw. Loctite 242 recommended.
D. Reinstall handle.
E. Repeat for inside escutcheon (not shown).
OUTSIDE ESCUTCHEON
FORM 57018 Rev. B
OUTSIDE HANDLE
5/32"
SOCKET CAP SCREW
242
LOCTITE
RECOMMENDED
A
B
C
D
E
F
PAGE 3
SCHLAGE COBRA MPM
CHANGE PIN
LOCK CASE
BOLT
(
AUTOBOLT SHOWN
02-10-2005
)
Advertisement
