• Cartridge • Hardware kit TOOLS AND MATERIALS REQUIRED The QC10-CBR is Tested and Certified by NSF International to NSF/ANSI Standard 42/53. • Phillips screwdriver • Adjustable wrench (for 1/4-inch male threaded parts) The QC10-EP is Tested and Certified by NSF • Tape measure...
INSTALLATION Outlet For cold water use only. NOTE: Make certain that installation complies with all state NOTE: Inlet Outlet and local laws and regulations. Inlet The contaminants or other substances removed or NOTE: reduced by the selected cartridge are not necessarily 11"...
FILTER CARTRIDGE REPLACEMENT TROUBLESHOOTING (R1) Relieve pressure by turning off water supply to the filter Leaks: and dispensing water from the faucet..Between head and cartridge (R2) (a) Twist cartridge away from the locked position to the unlock position , and (b) remove cartridge (R2). 1.
Test Conditions: specified in NSF/ANSI 42 and 53. Flow Rate = 0.5 gpm (QC10-CBR & QC10-EP) Do not use with water that is microbiologically WARNING: = 0.75 gpm (QC-GAC, QC10-TSGAC) unsafe or of unknown quality without adequate disinfection before or after the system.
Page 6
6 • PENTEK QC10 SERIES Installation and Operation Manual ®...
Page 7
PENTEK • 7 QC10 SERIES Installation and Operation Manual ®...
Page 8
All Pentair trademarks and logos are owned by Pentair, Inc. or its affiliates. All other registered and unregistered trademarks and logos are the property of their respective owners. Because we are continuously improving our products and services, Pentair reserves the right to change specifications without prior notice.
Need help?
Do you have a question about the QC10-CBR and is the answer not in the manual?
Questions and answers