FC SERIES WATER FILTRATION SYSTEMS
INSTALLATION, OPERATION & MAINTENANCE GUIDE
QC7I FC
COLDRINK® 4FC INSURICE® 4FC-S
QC7I FC-S
COLDRINK 7FC
QC7I FC5
QC7I FC5-S
INTRODUCTION
The new Pentair® Everpure® FC Series water filtration systems are designed to provide optimum water characteristics for its specified
applications. These systems can help reduce equipment maintenance, extend equipment life, and help improve the quality and
consistency of your products. Built with high quality materials, each system is quality inspected prior to shipment. Proper system
installation and routine filter changes will ensure years of trouble-free operation and performance.
NOTES
Do not discard. Give this guide to the owner/operator after installation.
• Installation must conform to all local plumbing codes and
regulations.
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
• Connect system to cold water supply only.
Water temperature must not exceed 100°F (38°C).
• Do not solder plumbing connections attached to the assembly.
High temperature will damage these components.
OPERATING SPECIFICATIONS
For use on cold water only.
Pressure Requirements:
Temperature:
Refer to this manual for general installation, operation, and maintenance requirements.
PENTAIR® EVERPURE FC SERIES WATER FILTRATION SYSTEMS INSTALLATION, OPERATION & MAINTENANCE GUIDE
INSURICE 7FC-S
10 - 125 psi, non-shock
(0.7 - 8.6 bar), non-shock
35 -100°F (2 - 38°C)
• Do not mount the system behind equipment. The unit must be
easily accessible for filter replacement.
• Do not install system where it may interfere with moving
equipment, carts, mops or any other item that may cause
damage.
• Allow a minimum of 21/2" (6.35 cm) clearance under the filter to
facilitate cartridge change.
• Not for residential use. For foodservice applications only.
FOODSERVICE.PENTAIR.COM
Need help?
Do you have a question about the FC Series and is the answer not in the manual?
Questions and answers