Installation; Connections - IBM 04N7322 Owner's Manual

3828TUO032A-1 99.5.31 1:34 PM ˘ ` A5

Installation

The supply voltage is marked on the ID label located on the rear
panel of the monitor. If your local voltage is different, do not use the
monitor and contact your supplier before using the display.

Connections

To connect your monitor after the video adapter is properly installed:
1. Turn OFF the power to your computer and all its attached options.
2. Position the monitor and the computer so that you can easily
3. Connect the signal cable with D-sub connector to the graphics
4. Tighten the screws on the video cable connectors to keep them
5. Connect the power cord to the AC receptacle on the back of the
6. The socket-outlet should be installed near the equipment and
get to the back panel of each.
board on your PC as described in your PC Owner's Manual.
from coming loose and to prevent radio and TV interference.
monitor. Plug the other end of the power cord into a properly
grounded electrical outlet.
should be easily accessible.
A5