Table of Contents
Advertisement
Diagnostic error code
025-196-XXX IDE interface test halt, error threshold
exceeded
025-197-XXX IDE interface test warning
025-198-XXX IDE interface test aborted
025-199-XXX IDE interface test failed, cause unknown
030-000-XXX SCSI interface Test Passed
030-00X-XXX 030-01X-XXX SCSI interface failure
030-027-XXX SCSI interface configuration/setup error
030-03X-XXX 030-04X-XXX SCSI interface error
030-195-XXX SCSI interface test aborted by user
030-196-XXX SCSI interface test halt, error threshold
exceeded
54
Hardware Maintenance Manual
FRU/Action
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Go to "Undetermined problems" on page 64
1. Go to "Undetermined problems" on page 64
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Replace component under function test
No action
1. SCSI signal cable
2. Check AC/DC power adapter
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Check AC/DC power adapter
3. SCSI device
4. SCSI adapter card, if installed
5. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
Advertisement
Table of Contents
