Table of Contents
Advertisement
Diagnostic error code
000-026-XXX FLASH data error
000-027-XXX BIOS Configuration/Setup error
000-034-XXX BIOS Buffer Allocation failure
000-035-XXX BIOS Reset Condition detected
000-036-XXX BIOS Register error
000-038-XXX BIOS Extension failure
000-039-XXX BIOS DMI data error
000-195-XXX BIOS Test aborted by user
000-196-XXX BIOS test halt, error threshold exceeded
000-197-XXX BIOS test warning
000-198-XXX BIOS test aborted
000-199-XXX BIOS test failed, cause unknown
46
Hardware Maintenance Manual
FRU/Action
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
1. Run Setup
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
3. System board
1. Reboot the system
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
3. Run memory test
4. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. Adapter card
3. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Flash the system and retest. See "Updating (flashing)
BIOS from a disc" on page 99
3. Go to "Undetermined problems" on page 64
1. Go to "Undetermined problems" on page 64
2. Flash the system and re-test
3. Replace component under function test
Advertisement
Table of Contents
