Table of Contents
Advertisement
Diagnostic error code
000-250-XXX BIOS APM failure
000-270-XXX BIOS ACPI failure
001-000-XXX System test passed
001-00X-XXX System error
001-01X-XXX System error
001-024-XXX System addressing test failure
001-025-XXX System checksum value error
001-026-XXX System FLASH data error
001-027-XXX System configuration/setup error
001-032-XXX System device controller failure
001-034-XXX System device buffer allocation failure
001-035-XXX System device reset condition detected
001-036-XXX System register error
001-038-XXX System extension failure
001-039-XXX System DMI data structure error
001-040-XXX System IRQ failure
001-041-XXX System DMA failure
001-195-XXX System test aborted by user
001-196-XXX System test halt, error threshold exceeded
FRU/Action
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
No action
System board
System board
System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
1. Run Setup
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
3. System board
System board
1. Reboot the system
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
3. Run memory test
4. System board
System board
System board
1. Adapter card
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
2. System board
1. Power-off/on system and re-test
2. System board
1. Power-off/on system and re-test
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
Chapter 7
.
Symptom-to-FRU index
47
Advertisement
Table of Contents
