Diagnostic error code
015-197-XXX USB port test warning
015-198-XXX USB port test aborted
015-199-XXX USB port test failed, cause unknown
018-000-XXX PCI card test passed
018-0XX-XXX PCI card failure
018-195-XXX PCI card test aborted by user
018-196-XXX PCI card test halt, error threshold exceeded
018-197-XXX PCI card test warning
018-198-XXX PCI card test aborted
018-199-XXX PCI card test failed, cause unknown
018-250-XXX PCI card services error
020-000-XXX PCI interface test passed
52
Hardware Maintenance Manual
FRU/Action
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Go to "Undetermined problems" on page 64
1. Go to "Undetermined problems" on page 64
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Replace component under function test
No action
1. Riser card, if installed
2. System board
1. PCI card
2. Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Go to "Undetermined problems" on page 64
1. Go to "Undetermined problems" on page 64
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Replace component under function test
1. PCI card
2. Riser card, if installed
3. System board
No action