Table of Contents
Advertisement
Diagnostic error code
020-0XX-XXX PCI interface error
020-195-XXX PCI test aborted by user
020-196-XXX PCI test halt, error threshold exceeded
020-197-XXX PCI test warning
020-198-XXX PCI test aborted
020-199-XXX PCI test failed, cause unknown
020-262-XXXPCI system error
025-000-XXXIDE interface Test Passed
025-00X-XXX 025-01X-XXX IDE interface failure
025-027-XXX IDE interface Configuration/Setup error
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface
failure
025-195-XXX IDE interface Test aborted by user
FRU/Action
1. PCI card
2. Riser card, if installed
3. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Go to "Undetermined problems" on page 64
1. Go to "Undetermined problems" on page 64
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Replace component under function test
1. PCI card
2. Riser card, if installed
3. System board
No action
1. IDE signal cable
2. Check power supply voltages
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 99
3. Reseat IDE signal cable
4. IDE device
5. System board
1. IDE signal cable
2. Check AC/DC power adapter
3. Reseat IDE signal cable
4. IDE device
5. System board
Information only Re-start the test, if necessary
Chapter 7
.
Symptom-to-FRU index
53
Advertisement
Table of Contents
