Table of Contents
Advertisement
v Do not bend the disc.
Caring for the CD-RW / DVD-ROM Combination Drive
To protect your CD-RW/DVD-ROM Combination Drive during operation, observe
the following precautions:
v Do not move the drive when it is in use. Doing so might cause data error or
v Avoid exposing the drive to the following conditions:
v Do not insert foreign objects into the drive.
v Do not stack objects on the drive.
v Do not remove the drive cover or attempt to service the drive.
v Remove any discs from the disc drawer and make sure that the drawer is closed
v Keep the original packing materials. If you need to ship the drive unit to a
Manually ejecting a disc
In case of a power failure, and the drive will not allow the disc to eject, turn off
the computer, and straighten a large paper clip to form a tool. The straightened
end must extend at least 45 mm (1.8 in.). Insert the extended end into the
emergency eject hole on the front of the drive (see "Front view of the drive" on
page 1-3). Push the paper clip until the tray opens. Gently pull out the tray until
you can remove the disc.
Installing software
All of the software for the drive is contained on the User's Guide and Software
CD. The User's Guide and Software CD contains this User's Guide, Multimedia
Center for Think Offerings, DLA, and Intervideo WinDVD. DLA is installed when
you install the Multimedia Center for Think Offerings.
Complete the following procedure to install the software:
1. Insert the User's Guide and Software CD into the drive. If the CD starts
2. If the CD does not automatically start, click Start, and then click Run.
3. Type e:\launch.bat where e is the drive letter of the CD or DVD drive.
4. Click OK.
5. Select your language.
1-6
ThinkCentre and Lenovo CD-RW/DVD-ROM Combination Drive (Serial ATA) User's Guide
might damage the drive or discs.
– High humidity
– High temperature
– Excessive dust
– Mechanical vibration
– Sudden shock or dropping
– Placement on an inclined surface
– Direct sunlight
– Sudden temperature changes
before moving the drive unit.
different location, use the original packing materials to ensure that the drive is
transported safely.
45 mm
1.8 in
automatically, skip to Step 6.
Advertisement
Table of Contents
