Connection Description Fortv Function - BMW X5 (E53) LHD Installation Instructions Manual

12. Connection description forTV function

!
This section is only required if the car is also to be upgraded with the TV function.
To complete the upgrade the required parts (video module,TV amplifier and small parts) must
be ordered separately using the electronic parts catalogue (EPC) and installed.
In addition the appropriate branches of the wiring harnesses A must be connected as follows:
Release the tied back branch A8, angled coaxial socket casing on the on-board monitor
wiring harness A and connect it to the TV amplifier installed previously above the left wheel
arch.
Release the tied back branch A11, angled coaxial socket casing on the on-board monitor
wiring harness A and connect it to the TV amplifier installed previously above the right wheel
arch.
Disconnect branch A22, blue 18-pin socket casing with the sticker "NAVI" on the on-board
monitor wiring harness A from the navigation computer.
Release tied back branch A24, blue 18-pin socket casing with the sticker "NAVI+TV" on the
on-board monitor wiring harness A and connect it to the blue 18-pin plug casing on the
navigation computer.
Branch A22, blue 18-pin socket casing with the sticker "NAVI" , which you previously
disconnected is to be tied back (not required).
Release tied back plug connection A17+A18 on the on-board monitor wiring harness A,
disconnect it and connect branch A17, blue 18-pin plug casing on the on-board monitor
wiring harness A, to the blue 18-pin socket casing on the video module, which you previously
installed in the multi-functional tray under the spare wheel.
Tie back branch A18, blue 18-pin plug casing on the on-board monitor wiring harness A
(no longer required).
In addition, release the tied back branches A19 and A20, coaxial socket casings, and
branch A16, white 18-pin socket casing on the on-board monitor wiring harness A, and
connect them to the video module, which you previously installed in the multi-functional
tray under the spare wheel.
Connect branches A19 and A20, coaxial socket casings, to the two coaxial plus casings on
the video module.
Connect branch A16, white 18-pin socket casing, to the white 18-pin plug casing on the video
module.
!
If the car is upgraded with the TV function at a later date, the system must be recoded. For
further details refer to section "11. Coding and concluding work".
Retrofit/Installation kit No. 65 90 0 025 169
Installation instructions No. 01 29 0 030 090
Issue date: 10.2001
EN/24