Subaru Select Monitor - Subaru Forester 2001 Service Manual

ABS (DIAGNOSTICS)

6. Subaru Select Monitor

A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
S006503A1601
1) Prepare Subaru Select Monitor kit.
2) Connect diagnosis cable to Subaru Select
Monitor.
3) Insert cartridge into Subaru Select Monitor.
<Ref. to ABS-10, SPECIAL TOOLS, PREPARA-
TION TOOL, General Description.>
4) Connect Subaru Select Monitor to data link
connector.
(1) Data link connector located in the lower por-
tion of the instrument panel (on the driver's
side).
(2) Connect diagnosis cable to data link con-
nector.
SUBARU SELECT MONITOR
S006503
S006503A16
S2M0285
S2M0286
S2M2157
5) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(1) Power switch
6) On the Main Menu
the {Each System Check} and press the [YES] key.
7) On the System Selection Menu
screen, select the {Brake Control System} and
press the [YES] key.
8) Press the [YES] key after displayed the infor-
mation of engine type.
9) On the
select the {Diagnostic Code(s) Display} and press
the [YES] key.
10) On the Diagnostic Code(s) Display
screen, select the {Current Diagnostic Code(s)} or
{History Diagnostic Code(s)} and press the [YES]
key.
NOTE:
¼ For detailed operation procedure, refer to the
SUBARU SELECT
MANUAL.
¼ For detailed concerning diagnostic trouble
codes, refer to the LIST OF DIAGNOSTICS
TROUBLE CODE. <Ref. to ABS-24, List of Diag-
nostics Trouble Code.>
ABS-18
display screen, select
ABS Diagnosis display screen,
MONITOR OPERATION
S2M0288D
display
display