Diagnostics Chart With Subaru Select Monitor - Subaru Forester 2001 Service Manual

DIAGNOSTICS CHART WITH SUBARU SELECT MONITOR

ABS (DIAGNOSTICS)
No.
1 CHECK IGNITION SWITCH.
2 CHECK BATTERY.
1) Turn ignition switch to OFF.
2) Measure battery voltage.
3 CHECK BATTERY TERMINAL.
4 CHECK COMMUNICATION OF SELECT
MONITOR.
1) Turn ignition switch to OFF.
2) Using the select monitor, check whether
communication to other system (such as
engine, TCM, etc.) can be executed normally.
5 CHECK COMMUNICATION OF SELECT
MONITOR.
1) Turn ignition switch to OFF.
2) Disconnect ABSCM&H/U connector.
3) Check whether communication to other
systems (such as TCM, engine etc.) can be
executed normally.
6 CHECK COMMUNICATION OF SELECT
MONITOR.
1) Turn ignition switch to OFF.
2) Connect ABSCM&H/U connector.
3) Disconnect ECM connector.
4) Check whether communication to other
systems (such as TCM, engine etc.) can be
executed normally.
7 CHECK COMMUNICATION OF SELECT
MONITOR.
1) Turn ignition switch to OFF.
2) Connect ECM connector.
3) Disconnect TCM connector.
4) Check whether communication to other
systems (such as engine etc.) can be
executed normally.
8 CHECK COMMUNICATION OF SELECT
MONITOR.
1) Turn ignition switch to OFF.
2) Connect TCM connector.
3) Disconnect cruise control module connec-
tor.
4) Check whether communication to other
systems (such as engine, TCM etc.) can be
executed normally.
NOTE:
If the vehicle is not equipped with cruise con-
trol: Go to step 9.
Step
Is ignition switch ON?
Is voltage more than 11 V? Go to step 3.
Is there poor contact at
battery terminal?
Are the name and year of
the system displayed on
the select monitor?
Are the name and year of
the system displayed on
the select monitor?
Are the name and year of
the system displayed on
the select monitor?
Are the name and year of
the system displayed on
the select monitor?
Are the name and year of
the system displayed on
the select monitor?
ABS-92
Check Yes
Go to step 2.
Repair or tighten
battery terminal.
Go to step 10.
Go to step 10.
Inspect ECM.
Inspect TCM.
Inspect cruise
control module.
No
Turn ignition
switch to ON, and
select ABS mode
using the select
monitor.
Charge or replace
battery.
Go to step 4.
Go to step 5.
Go to step 6.
Go to step 7.
Go to step 8.
Go to step 9.