Read Diagnostic Trouble Code - Subaru Forester 2001 Service Manual

ABS (DIAGNOSTICS)

7. Read Diagnostic Trouble Code

A: OPERATION
1. WITHOUT SUBARU SELECT MONITOR
S006508A1602
1) Take out diagnosis connector from side of driv-
er's seat heater unit.
6) After the start code (11) is shown, the trouble codes will be shown in order of the last information first.
These repeat for a maximum of 3 minutes.
NOTE:
¼ When there are no trouble codes in memory, only the start code (11) is shown.
¼ When on-board diagnosis of the ABS control module detects a problem, the information (up to a maxi-
mum of three) will be stored in the EEPROM as a trouble code. When there are more than three, the most
recent three will be stored. (Stored codes will stay in memory until they are cleared.)
2. WITH SUBARU SELECT MONITOR
Refer to SUBARU SELECT MONITOR for information about how to obtain and understand trouble codes.
<Ref. to ABS-18, Subaru Select Monitor.>
READ DIAGNOSTIC TROUBLE CODE
S006508A16
B4M0231E
S006508A1601
S006508
2) Turn ignition switch OFF.
3) Connect diagnosis connector terminal 6 to
diagnosis terminal.
4) Turn ignition switch ON.
5) ABS warning light is set in the diagnostic mode
and blinks to identify trouble code.
ABS-20
B4M0232A