Assembly - Toshiba GSC-R60 Service Manual

5-2. Assembly

Step Figure
1
2
3
4
5
6
Install the FPC of LCD ASSY
(HA54) insert the hole of Main
Cover ASSY (AA01).
Use the screws A328*2 and
connect the LCD and a LCD Plate
(A313) to Main Cover ASSY.
Connect the Sensor Cover ASSY
(AA14) to Main Cover ASSY
(AA01).
Tape is stuck as shown, thermal
Sheet A (A346) is stuck on Battery
Case ASSY (AC11).
Use the screw A331 and connect
the SENSOR PCB ASSY (U006)
to Battery Case ASSY (AC11).
Use the screws A332*4 and A325
and connect the Battery Case
ASSY (AC11) to Main Cover
ASSY (AA01).
A325
Install the FLASH-MAIN FPC
Be careful
of the form
(W999) to MAIN PCB ASSY
of FPC.
(U001), Insulating tape is stuck on
a connector.
Discription
34
Remark
Be careful of direction of the hinge
of LCD ASSY (HA54).
Tighten screws certainly so that
there is no slack.
When the lead wire of a Battery
Case ASSY (AC11) is long, it
bundles to about 5cm and stops
with the tape.
A screw A325 use near the tripod
screw.
FPC connector is a lower point of
contact.
Be careful of direction of FLASH-
MAIN FPC (W999) to prevent
mistakes.