Sharp AR-SP3 (SPF) Service Manual page 8

AR-SP3
16) Insert the power plug into the outlet and turn the main switch of
the copier to the "ON" position.
17) Perform SIM setting.
Execute simulation [2] of [26] and enter [1].
18) Check the ON/OFF operation of the open detection sensor and
book detection sensor.
G
Execute simulation [2] of [2] and check that the indicator on the
operation panel lights up and goes out by opening and closing
the FAX-SPF. When the book detection sensor is turned
ON/OFF, the drum replacement lamp is turned ON/OFF accord-
ingly.
19) Check the copy ratio, and then check the center displacement and
leading edge image void.
G
Place an original on the document glass and make a copy. Then,
place an original in the document feeder tray and make a copy.
If the center of the copy from the document glass is displaced
from the copy from the document feeder, adjust the center refer-
ring to the service manual.
3. AR-DE9 Installation Manual
Turn the main switch to the "OFF" position and remove the power plug
from the outlet.
1) Remove the DV cartridge from the copier.
G
Open the bypass tray, side cover, and front cover, and then
remove the DV cartridge.
3
2
2) Make the copier upright.
G
Close the front cover, side cover, and bypass tray, and then
make the copier upright in the orientation shown in the illustra-
tion.
3) Remove the OP gear cover and rubber feet from the bottom of the
copier.
G
Remove the screw and remove the OP gear cover.
Then, take off and remove the rubber feet.
4) Install the second cassette unit to the copier.
G
If the second cassette unit is aligned to the copier, it can be posi-
tioned automatically.
Hold the copier lightly to prevent it from toppling down and
secure the second cassette unit with four screws (M4 × 16).
1
5) Remove the rear cover and connect the connector.
G
Remove the screw and remove the rear cover.
Then, connect the connector of the second cassette unit to that
of the copier.
2 – 6