Sharp AR-SP3 (SPF) Service Manual page 3

[2] UNPACKING AND INSTALLATION
1. AR-SP3 Instalation Manual
Turn the main switch to the "OFF" position and remove the power plug
from the outlet.
1) Remove the document cover.
G
Remove the document cover from the copier.
2) Remove the rear cabinet.
G
Remove the four screws and then remove the rear cabinet.
3) Remove the Mylar sheet from the rear cabinet.
G
Remove the Mylar sheet that covers the hole for the actuator of
sensor unit.
4) Remove the hinge guides L and R.
G
Remove the screws (two for each) and then remove the hinge
guides L and R.
5) Attach the hinge guides L and R.
G
Attach the hinge guides L and R by fitting the pawls (two for
each) into the frame of the copier and secure them with the two
screws (M3 × 8) for each that have been removed in step 3.
6) Place the SPF on the copier.
2 – 1
AR-SP3