Yamaha TW200 Owner's Manual page 88

MOTORCYCLE CARE AND STORAGE
8 Do not use any harsh chemical
products on plastic parts. Be
sure to avoid using cloths or
1
sponges which have been in
contact with strong or abra-
2
sive cleaning products, sol-
vent or thinner, fuel (gasoline),
3 rust removers or inhibitors,
brake fluid, antifreeze or elec-
trolyte.
4
8 Do
not use
washers or steam-jet cleaners
5
since they cause water seep-
age and deterioration in the
6
following areas:
wheel and swingarm bearings,
7
fork and brakes), electric com-
ponents (couplers,
8
tors, instruments,
and lights), breather hoses
and vents.
9
8 For
with a windshield: Do not use
strong
sponges as they will cause
dulling or scratching. Some
cleaning compounds for plas-
tic may leave scratches on the
windshield. Test the product
on a small hidden part of the
windshield to make sure that it
high-pressure does not leave any marks. If
the windshield is scratched,
use a quality plastic polishing
compound after washing.
seals (of
After normal use
Remove dirt with warm water, a mild
connec-
detergent, and a soft, clean sponge,
switches
and then rinse thoroughly with clean
water. Use a toothbrush or bottle-
brush
Stubborn dirt and insects will come
off more easily if the area is covered
with a wet cloth for a few minutes
before cleaning.
motorcycles equipped
cleaners or hard
for hard-to-reach areas.
7-2
After riding in the rain, near the sea
or on salt-sprayed roads
Since sea salt or salt sprayed on
roads during winter are extremely
corrosive in combination with water,
carry out the following steps after
each ride in the rain, near the sea or
on salt-sprayed roads.
NOTE:
Salt sprayed on roads in the winter
may remain well into spring.
1. Clean the motorcycle with cold
water and a mild detergent, after
the engine has cooled down.
cC
Do not use warm water since it
increases the corrosive action of
the salt.
2. Apply a corrosion
spray on all metal, including
chrome- and nickel-plated, sur-
faces to prevent corrosion.
ECA00012
protection