Cleaning The Feed Module - Kodak I200 User Manual

Cleaning the feed module

A-61167 April 2005
7. Inspect the tires.
If the separator module tires show signs of wear or damage, replace the
tires or the separator module.
8. Insert the separator module and align the shaft ends.
9. Press until the separator module clicks into place.
10. Go to the next section to clean the feed module.
1. Push against the raised edge on the left side of the front roller cover to
the side and pull the cover up and out to remove it.
NOTE: You may need to lift the input tray slightly to remove the front
roller cover.
2. Remove the feed module by pushing it to the right and lifting it out.
Front roller cover
Feed module
25