Maintenance; Cleaning The Scanner - Kodak I200 User Manual

Maintenance

Cleaning the scanner

A-61167 April 2005
The scanner will collect dust and other debris during routine scanning.
For optimal scanner performance, follow the detailed cleaning instructions
in this section and clean the feed module tires, separator module tires, imaging
guides, transport area, and paper path at least once per week. Clean the
scanner and paper path daily if you are scanning carbonless paper or
newsprint, or if you are using the imprinter.
Use only these cleaning materials:
Kodak Digital Science Roller Cleaning Pads (24)
Staticide Wipes for Kodak Scanners (144)
Kodak Digital Science Transport Cleaning Sheets (50)
IMPORTANT: Staticide Wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the Material Data Safety Sheet (MSDS) for more information.
The MSDS is available on the Kodak web site at
www.kodak.com/go/MSDS.
Allow all tires to dry completely before using the scanner.
NOTES: The use of any other cleaning materials could damage your scanner.
Use fresh cleaning material unless otherwise indicated.
In addition to the recommended cleaning supplies, you may use a
vacuum cleaner to remove debris from the scanner.
Some debris from the rubber tires on the feed module and separator
module is normal. Tire debris does not always mean that the tires
are worn or damaged. After cleaning, inspect the tires for wear and
replace the separator module or feed module if necessary.
To order cleaning supplies, refer to Appendix B, Supplies
and Accessories.
Item CAT No.
853 5981
896 5519
169 0783
23