Point Grey Flea3 USB 3.0 Technical Reference
7.12 Image Flip/Mirror
The camera supports horizontal image mirroring. The mirror image operation is performed on the camera using the
on-board frame buffer
7.12.1
MIRROR_IMAGE_CTRL: 1054h
Format:
Field
Presence_Inq
Mirror_Image_Ctrl
7.13 Embedded Image Information
This setting controls the frame-specific information that is embedded into the first several pixels of the image. The first
byte of embedded image data starts at pixel 0,0 (column 0, row 0) and continues in the first row of the image data: (1,
0), (2,0), and so forth. Users using color cameras that perform Bayer color processing on the computer must extract
the value from the non-color processed image in order for the data to be valid.
Each piece of information takes up 32-bits (4 bytes) of the image. When the camera is operating in Y8 (8bits/pixel)
mode, this is therefore 4 pixels worth of data.
The following frame-specific information can be provided:
Timestamp
n
Gain
n
Shutter
n
Brightness
n
Exposure
n
White Balance
n
Frame counter
n
Strobe Pattern counter
n
GPIO pin state
n
ROI position
n
Revised 9/27/2012
Copyright ©2011-2012 Point Grey Research Inc.
(page
35).
Bit
Presence of this feature.
[0]
0: Not Available, 1: Available
[1-30]
Reserved.
Value
[31]
0: Disable horizontal (mirror) image flip
1: Enable horizontal (mirror) image flip
Embedded image values are those in effect at the end of shutter integration.
7 Imaging Parameters and Control
Description
119