Error Messages/Troubleshooting - ADC 6016 Instruction Manual

8. ERROR MESSAGES/TROUBLESHOOTING

If an error occurs during a measurement,
the measurement is discontinued and a
corresponding error code is displayed
(Example: Err 2).
Error No. Possible cause(s)
Err 1 No pulse has been detected.
Err 2 Unnatural pressure impulses influenced the measurement
result. The arm was moved during the measurement.
Err 3 The inflation of the cuff takes too long. The cuff is not
correctly seated.
Err 5 The measured readings indicated an unacceptable difference
between systolic and diastolic pressures. Take another
reading following directions carefully. Contact your
doctor if you continue to get unusual readings.
Hi The measured reading exceeded 280mmHg or 200bpm.
Lo The measured reading fell below 30mmHg or 40bpm.