Clearing The Memory - ADC 6016 Instruction Manual

Further Information
+
When the unit is in verage Mode, the time between measurements
is carefully controlled to ensure accuracy. If you take successive
measurements when the unit is in the single measurement mode,
wait for 5 minutes in a relaxed position before you repeat a
measurement. Make sure all measurements are taken in a seated
position.
(MR1: Values of the last measurement.)
6.8.

Clearing the Memory

Attention!
To delete all stored readings, press the
MEMORY button for at least 7 seconds.
The display will show the symbol "CL"
and 3 short beeps will sound to indicate
deletion of stored readings.
Note:
If your last stored measurement was taken in the verage Mode,
you will see an "A" icon with a short beep during the deletion
procedure. (The display will show these symbols during deletion of
all stored measurements if the last measurement is taken from the
verage Mode). lso, you will clear the memory if you take the
batteries out.
(MR2: Values of the measurement before MR1.)