Memory - Displaying The Last 99 Measurements; Discontinuing A Measurement - ADC Advantage 6021 User Manual

5.7. Memory
At the end of a measurement, this monitor automatically stores each result with date
and time. Each unit stores 99 measurements. Models 6023 and 6022 store 99 meas-
urements each, for 2 users.
Viewing the stored values
With the unit off, press the Memory button. The display first shows "A", then shows an
average of all measurements stored in the unit. Please note: Measurements for
each user are averaged and stored separately. Be certain that you are view-
ing the measurements for the correct user.
Pressing the Memory button again displays the previous value. To view a particular
stored memory, press and hold the Memory button to scroll to that stored reading.
Memory full
Model 6021: The word "FULL" will be displayed to signal the oldest value is being
deleted before displaying the current reading.
All other Models (6022, 6023): The new measured value will
overwrite the oldest value without any visual notice.
Clear all values
If you are sure that you want to permanently remove all stored values,
hold down the Memory button (the instrument must have been switched
off beforehand) for about 7 seconds, until "CL" appears and then release
the button. If you do not want to clear the values, press the Start/ON/OFF button. To
permanently clear the memory, press the Memory button while "CL" is flashing.
Individual values cannot be cleared.

5.8. Discontinuing a Measurement

If it is necessary to interrupt a blood pressure measurement for any
reason (e.g the patient feels unwell), the Start/ON/OFF button can be
pressed at any time. The device then immediately lowers the cuff pres-
sure automatically.
16
1