Gree GWH12MB-K3DNE3G Service Manual page 18

Service Manual
Operation Guide
1. After putting through the power, press "ON/OFF" button on remote controller to turn on
the air conditioner.
2. Press "MODE" button to select your required mode:AUTO,COOL,DRY,FAN,HEAT.
3. Press "+" or "-" button to set your required temperature. (Temperature can't be
adjusted under auto mode).
4. Press 'FAN" button to set your required fan speed: auto, low, medium and high speed.
5. Press " " button to select fan blowing angle.
Replacement of Batteries in Remote Controller
1.Press the back side of remote controller marked with"
of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Note:
● During operation, point the remote control signal sender at the receiving window
on indoor unit.
● The distance between signal sender and receiving window should be no more than
8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp or
wireless telephone; remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please replace
batteries.
Technical Information
"as shown in the fig, and then push out the cover
Signal sender
Battery
Reinstall
Cover of
battery box
Remove
15