Without The Light Kit Assembly - Fanimation FPD8088 Owner's Manual

Adapter / Switch Cup Assembly:
1. Disassemble the Adapter Switch Cup Assembly by
removing three screws. (Figure 1)
2. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate assembly to the support
bracket using the two key slots in the socket
plate. Replace the third screw and securely tighten
all three screws. (Figure 2)
3. Disassemble the switch cup with light kit. (Figure 3)
4. Install the threaded plug from part bag onto the
switch cup. (Figue 4)
5. Assembly the switch cup onto the assembled
adapter with three screws. (Figure 5)

Without the Light Kit Assembly

12
Figure 1
Figure 2
Figure 3
Threaded Plug
Figure 4
Figure 5