Sony CNA-1 Operation Manual page 15

* The device number should be set as
follows:
- If the CCU is connected to the
CNA-1 with the CCA to LAN
converting function, set a different
device number from that of the
CCU on the network.
- If the Gateway function is activated
and the Gateway Emulation mode
is set to RCP, set a different device
number from that of the RCP on the
network.
- If the Gateway function is activated
and the Gateway Emulation mode
is set to CAM, set a different device
number from that of the CCU on the
network.
Note
When you set [Master Mode] to
[Enable], the Gateway Mode setting is
set to [Disable] automatically.
2. Gateway Configuration
Sets the Gateway function or transport
converting function.
For details about the transport
converting function, see "Transport
Converting Function Setting" (page 18).
Select [Enable] to use the Gateway
function or transport converting function.
Select [Enable] to
use the transport
converting
function.
Input the IP address of the target CNA-1
for the transport converting function.
Notes
• Do not set the Gateway function to
[Enable] when you do not plan to use
it, because the Gateway function
affects the other network device.
• The Gateway function cannot be set
to [Enable] when the CNA-1 is
working in the Master Mode.
• The Gateway function does not work
when the transport converting
function of the CNA-1 is set to
[Enable].
Set the
communication
settings for the
Gateway function or
transport converting
function.
Menu operation 15