Sony CNA-1 Operation Manual page 14

5. System Control
Restarts the CNA-1 or resets the
CNA-1's settings.
Check the box and click the [Reboot]
button to restart the CNA-1.
Check the box and click the [Factory
Default] button to reset the CNA-1 to the
factory settings.
Notes
• When restarting the CNA-1, close the
browser, then access the menu from
the browser again.
• The System Restore point is not
deleted even when you perform
[Factory Default]. Use the System
Restore function if needed.
14 Menu operation
CNS menu
[CNS] tab
[Apply] button
To display the CNS menu, Click the
[CNS] tab.
To apply the settings, click the [Apply]
button. The settings are stored in the
internal memory.
1. CNS Configuration
Sets the camera network system
connection.
When the CNA-1 works in the MCS mode,
the CNA-1 works as the master device by
selecting [Enable].
When you use the CNA-1 as the client by
selecting [Disable], input the IP address of
the connected master device to [Master IP
Address].
Select the CNS mode.
Input the device number of the CNA-1.*
When the CNA-1 works in the Bridge
mode, input the IP address of the
connected device.