Advanced; Virtual Server - D-Link DIR-866L User Manual

Section 3 - Configuration
The Virtual Server option allows you to open a single port. If you would like to open a range of ports, refer to the next page.
Name: Enter a Name for the rule or select an Application name from
the drop-down menu. Select an Application name and click
<< to populate the Name field.
IP Address: Enter the IP Address of the computer on your local network
that you want to allow the incoming service to. If your computer
is receiving an IP address automatically from the router (DHCP),
your computer will be listed in the Computer Name drop-
down menu. Select your Computer Name and click <<.
Private Port/ Enter the port that you want to open next to Private Port and
Public Port: Public Port. The private and public ports are usually the same.
The public port is the port seen from the Internet side, and the
private port is the port being used by the application on the
computer within your local network.
Protocol Type: Select TCP, UDP, or Both from the drop-down menu.
Schedule:
The schedule of time when the Virtual Server Rule will be
enabled. The schedule may be set to Always, which will allow
the particular service to always be enabled. You can create your
own schedules in the Tools > Schedules section.
Inbound Filter: Select Allow All (most common) or a created Inbound filter.
You may create your own inbound filters from the Advanced
> Inbound Filter page.
Click on Save Settings.
D-Link DIR-866L User Manual

Advanced

Virtual Server

75