Table of Contents
Advertisement
Before replace the water system components, it will be necessary
to drain the system of water.
Replace the water pump
Disconnect electrical powe
Remove the front cover.
Unplug the lines connector
Loosen the screws, replace a new one.
Reverse the above step to reassemble.
Replace the Water Dump Valve
The water dump valve normally
if removal is necessary:
1
. Locate the water dump valv
2. Set the toggle switch to ICE.
3. While the ice machine is in th
drain hose for leakage.
A.
If the dump valve is le
B. If the dump valve is not leaking, do not remove it. Instead, follow
Cleaning Procedure".
R
eplace the cooling system components
Replace the condensing components, See Figure "
1.Replace the compressor and the compressor kit
If only need replace the compressor kit, remove the top panel and left panel, loc
compressor, take the clip, replace the wrong,
Reverse the above step to reassemble.
If need replace the compressor, remove
Unplug the lines and taken out the earth line, open the Process/Suction, evacuat
out the compressor, replace a new one, joint together, then recover refrigerant, weigh in the
nameplate charge.
Reverse the above st
2. Replace the fan motor and fan bla
Remove the top and right panel.
locate the fan motor, unplug th
holding bracket and fan motor bracket, taken out the damaged, replace a new one
Reverse the above step to reassemble.
3. Replace the hot gas valve, drier an
Remove the top panel.
r.
with the water pump, the water outlet tube of pump.
does not require removal for cleaning. To determine
e.
e freeze mode, check the dump valve's clear plastic outlet
aking, remove, disassemble and clean it.
the top cover, locate the compressor.
ep to reassemble.
de.
e lines connecting with the fan motor, loosen the screws of
d evaporator.
cooling system"
(includes relay
the "Ice Machine
, thermal protect).
e refrigerant, take
ate the
14
Advertisement
Table of Contents
