Table of Contents
Advertisement
2.Remove the front panel, l
3.Locate the cube size adjustment screw, and to make fuller c
1/36 turn (10°-15°). This will make the freezing cycle longer.
4. To shorten the freezing cycle and make cubes that are not
turn (10°-15°) counter clockwise.
5.After the next freezing cycle,
adjustment is required, do it early in the freeze cycle.
.
Expert advises the cube size have been adjusted
ok before leave factory, had better not adjust it.
Replace the water system components
Please see the water system drawing. The water leakage should be checked after this kind of operation
ocate the Electronic control box,
Control box
the cubes should have responded to the adjustment, if another
ubes, turn the screw clockwise about
as full, turn the adjustment screw 1/36
Correct size
Correct size
Too big
Too small
13
Advertisement
Table of Contents
